A few comments have come in regarding labeling and bundling of the motor wires. It is a small note in the manual that is easily overlooked. On the explanation of symbols page at the beginning of the manual shows an icon for labeling the wires. But when it is shown in Assembly steps A and B it is often missed. The reason for it’s note is two fold.
1. Bundling the wires at the end will make it significantly easier for it to route through the flexible hose later on in assembly.
2. So you will know which set of motor wires is which when you are wiring the control board near the end of assembly.
In this picture I transposed the text from earlier in the manual with the symbol you’ll see on the assembly step.
